Products 09/10/2021
Stainless Steel Fret Cutter

Having a closer approach to the fretboard side, TL-FC28S leaves the cut end as little as 1 m/m. A Small remainder makes a big difference.
The leverage cutter of high carbon steel saves your time and labor after all.

The fret pictured to your left is cut with C-C28**, while the right with TL-FC28S.
It is quite obvious the edge remained is “LESS” for easier filing afterwards,
We would appreciate your taking consideration of TL-FC28S as a substitute.
**Effective immediately, C-C28, Stainless Steel Wire Cutter is no longer available.

*Blades on existing product bite off, while TL-FC28S cut right at the
contact point.

This picture clearly shows how minutely the blade tip have been designed for both easy-cutting and endurance.

For your safety and prevention of unexpected damage to the neck, this TL-FC28S has a T-shaped lock system with an oblong cutout in the center.
Slide it upwards to LOCK, or downwards to UNLOCK.
- Specially designed blades
- leave the cut end minimal
- Rubber Grip
- for comfortable cut without slip