HOSCO Fret Saw Guide is designed for HOSCO fret saws.

HOSCO Fret Saw Guide

H-FSWG


Fret Saw Guide for TL-H-FSW series
Size : 195mm x 90mm x 25mm
Weight : 475g
Material

- banner1
Close Me!

Global image

This fret saw guide is designed for HOSCO fret saws.

  • Global image

    This fret saw guide is designed for HOSCO fret saws.

  • Hold the blade

    Three Neodymium magnets hold the saw blade.
    There is three Neodymium magnets at the red circles.

  • Control of depth

    Three Neodymium magnets backed Polyacetal guide draws the saw blade and support the cutting straightly and at right angle to the fingerboard.
    This part helps you not to cut too deeply by hitting against the steel spine of fret slotting saw.

  • Silicon rubbers

    The silicone rubber prevents the fret saw guide from slipping.
    The silicone rubber can be removed, if needed.
    If you would like to use a clamp for fixing the fret saw guide, please remove the silicone rubber on the side touching the clamp before using a clamp.

  • Triangle marks

    Please draw a line by pencil at the center of fingerboard from end to end.
    Please find the triangle marks at both ends of the fret saw guide and match the marks onto the center line.
    Then you will be able to cut a fret slot vertically against the fingerboard.








HOSCO Fret Saw Guide How to use...


1. At first, please note 2 points.
  1) This fret saw guide can adjust 0mm to 4.7mm slot depth by sliding the frame.
  2) Slide frame side has scale marks. 1 scale mark means 1mm depth adjustment.


2. Loose each wing screws and adjust the slide frame .
  And then screw tightly.


3. if you find the depth is shallow or too deep, please side the frame again and adjust the depth.


Animation link




It can cut deeply to 4.7mm.




High guide position can be adjustable by setting this guide upside down.






Copyright:©2007- HOSCO Inc. All Rights Reserved.